IV
Carts and Stands -
The appliance should be used only with a cart or stand recommended by the
manufacturer.
Heat -
The product should be situated away from heat sources such as radiators, heat
registers, stoves, or other products that produce heat.
NOTE TO CATV SYSTEM INSTALLER
Article 820-40 of the NEC (National Electrical Code) provides guidelines for proper grounding
and, in particular, specifies that the cable ground shall be connected to the grounding system
of the building, as close to the point cable entry as practical.
This “bolt of lightning” indicates uninsulated material
within your unit may cause an electrical shock. For the
safety of everyone in your household, please do not
remove product covering.
The “exclamation point” calls attention to features for
which you should read the enclosed literature closely
to prevent operating and maintenance problems.
CAUTION:TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY
INSERTED.
ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE
LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU'AU
FOND.
WARNING
This device complies with Part 15 of the FCC (U.S.A.) Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
FCC Regulations and Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a
residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause interference to radio or television reception (which you can determine by turning the equipment off and on),
you are encouraged to try to correct the interference by one or more of the following measures:
•
Change the position of the satellite receiver with respect to the radio or television equipment that is receiving
the interference.
•
Move the satellite receiver away from the equipment that is receiving the interference.
•
Plug the satellite receiver into a different outlet so that the satellite receiver and the equipment receiving the
interference are on different branch circuits.
•
Use shielded cables and I/O cords with this equipment to comply with the relevant FCC regulations.
•
If these measures do not eliminate the interference, you should consult your dealer or an experienced
radio/television technician for help.
IMPORTANT
Any change or modifications to the equipment by the user not expressly approved by the guarantee or manufacturer could void
the user’s authority to operate such equipment.
Domestic use USA - For units used at 100-120V use only the power supply cord which is supplied with the product.
Summary of Contents for DSX 5250
Page 1: ......
