8
EN
8 Product
information
Note
•
Product information is subject to change without prior
notice.
General information
AC power adaptor
Model: AS100-050-
AB200 (Philips)
Input: 100-240 V,
50/60 Hz, 0.5 A
Output: 5 V 2.0 A
Operation power
consumption
< 10 W
Standby power
consumption
< 1 W
Dimensions: main unit
(W x H x D)
137 x 62 x 141 mm
Weight: main unit
0.54 kg
Amplifier
Rated output power
2 x 2 W RMS
Frequency response
125 - 16000 Hz, -3 dB
Signal to noise ratio
> 55 dBA
Total harmonic
distortion
< 1%
AUDIO IN
650 mV RMS
Speakers
Speaker impedance
4 Ohm
Speaker driver
1.5'' full range
9 Troubleshooting
Warning
•
Never remove the casing of this product.
To keep the warranty valid, never try to repair
the product yourself.
If you encounter problems when using this
product, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page
(www.philips.com/support). When you contact
the Consumer Care, make sure that the
product is nearby and the model number and
serial number are available.
No power
•
Make sure that the AC power plug of the
unit is connected properly.
•
Make sure that there is power at the AC
outlet.
No sound or poor sound
•
Adjust the volume of your docking speaker.
•
Adjust the volume of your iPod/iPhone or
external audio device.
Docked iPod/iPhone can't be charged.
•
Make sure that the iPod/iPhone is
compatible with this product.
•
Make sure that the iPod/iPhone is securely
docked.
•
Remove the protective case of your iPod/
iPhone.
•
Make sure that the power supply is available.
Clock is reset.
•
If power is interrupted, the clock on this
device is reset.
•
To synchronize the clock with your iPod/
iPhone, make sure that the power is available,
and then dock your iPod/iPhone again.
No response from the unit
•
Disconnect and reconnect the AC power
plug, and then turn on the docking speaker
again.