8
6.8
Camera/Lens Wiring
WARNING: Only use the cables specified under
"INSTALLATION, Cable Requirements" for wiring
of all cameras and lenses.
6.8.1
Power Connections: LTC 9483/50C,
LTC 9488/50C
1. Cut the camera power cord, leaving enough cable to allow
connection to the terminal block. Strip no less than 6 mm
(0.25 in) and no more than 8 mm (0.31 in) of insulation
away from the wire. Connect these wires to the left side or
the top side of the terminal block. See
Figure 7
.
Figure 7: Camera Power Connection
2. The terminal block provided on /X0 units accepts wire
ranging from 20 to 14 AWG or 1.5 mm
2
. When using larger
wire sizes, splice to a smaller wire at the terminal block end.
3. All electrical connections are made through the power
connector. See
Figure 8
.
Electrical Connections: LTC 9483/50C
Electrical and Control Connections: LTC 9488/50C
Figure 8: Electrical Connections
4. Connect power input cable to the provided connector plug.
Refer to wiring diagrams for pin connections. The following
table corresponds to
Figure 9: Power Connector
.
230 Vac, 50 Hz Enclosures
Pin
Function
Color
1
1
AC Neutral
Blue
2
AC Hotl
Brown
3
NC2t
2
--
4
Ground
Green/Yellow
1. Color codes indicate harness wire color.
2. NC - No connection, Do Not Use.
Camera
Neutral
Wire
Camera
Line
Wire
Video
BNC Jack
Power
Connector
Control
Connector
Video BNC
Jack
Power
Connector
