13
Set clock
1
In standby mode, press
CLOCK/
DISPLAY
on the remote control to
activate the clock setting mode.
»
The hour digits are displayed and
begin to blink.
2
Press / to set the hour.
3
Press
CLOCK/DISPLAY
.
»
The minute digits are displayed and
begin to blink.
4
Press / to set the minute.
5
Press
CLOCK/DISPLAY
to confirm.
Turn on
Press .
»
The unit switches to the last selected
source.
Switch to standby
Press again to switch the unit to standby
mode.
»
The clock (if set) appears on the
display panel.
Switch to ECO standby mode:
Press and hold for more than 3 seconds.
»
[ECO STANDBY] (Eco standby) is
displayed for 3 seconds and then
disappeared.
Tip
•
The unit switches to Eco Power Standby mode after
15 minutes in standby mode.
Switch between standby mode and ECO
standby mode:
Press and hold for more than 2 seconds.
Prepare the remote control
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
To insert the remote control battery:
1
Open the battery compartment.
2
Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Note
•
If you are not going to use the remote control for a
long time, remove the batteries.
•
Do not use old and new or different types of
batteries in combination.
•
Batteries contain chemical substances, so they should
be disposed of properly.
a
b
c
EN
EN.indd 13
6/14/2011 4:33:32 PM