14
EN
Note
•
Before pressing any function button on the remote
control, first select the correct source with the remote
control instead of the main unit.
•
If you are not going to use the remote control for a
long time, remove the battery.
Auto install radio stations
When you connect power and no radio
stations are stored, the DCM250 automatically
begins to store radio stations.
1
Connect the DCM250 to the power
supply.
»
[AUTO INSTALL - PRESS PLAY] (auto
install - press the PLAY button) is
displayed.
2
Press on the main unit to start
installation.
»
The DCM250 automatically stores
radio stations with sufficient signal
strength.
»
When all the available radio stations
are stored, the first preset radio station
is broadcast automatically.
Set clock
1
In standby mode, press
PROG
to activate
the clock setting mode.
»
The 12 hour or 24 hour format is
displayed.
2
Press / to select 12 hour or 24 hour
format.
3
Press
PROG
.
»
The hour digits are displayed and begin
to blink.
4
Press / to set the hour.
5
Press
PROG
.
»
The minute digits are displayed and
begin to blink.
6
Press / to set the minute.
7
Press
PROG
to confirm.
Turn on
1
Press .
»
The DCM250 switches to the last
selected source.
Switch to standby
1
Press to switch the DCM250 to
standby mode.
»
The backlight on the display panel is
reduced.
»
The clock (if set) appears on the
display panel.
To switch the DCM250 to Eco Power
Standby mode:
1
In standby mode, press and hold for
more than 2 seconds.
»
The backlight on the display panel
turns off.
DCM250_DFU_37.indb 14
2011-7-13 10:18:53
