8
Note on the power supply lead (yellow)
When you connect other devices to this
V\VWHPHQVXUHWKDWWKHUDWLQJRIWKHFDU
circuit is higher than the total fuse value
of all the connected devices.
Notes on speaker connection
Never connect speaker wires to the
metal body or chassis of the car.
Never connect speaker wires with stripes
to one another.
Connect wires
Caution
Ensure that all loose leads are insulated with
electrical tape.
3 Get started
Caution
Use of controls or adjustments or performance
of procedures other than herein may result in
hazardous radiation exposure or other unsafe
operation.
Always follow the instructions in this chapter in
sequence.
Install the car audio
These instructions are for a typical installation.
+RZHYHULI\RXUFDUKDVGLIIHUHQWUHTXLUHPHQWV
make the corresponding adjustment. If you have
DQ\TXHVWLRQVUHJDUGLQJLQVWDOODWLRQNLWVFRQVXOW
your Philips car audio dealer.
Caution
This unit is designed for negative ground
(earth) 12 V DC operation only.
Always install this unit in the car dashboard.
Other locations can be dangerous as the rear
of the unit heats up during use.
7RDYRLGVKRUWFLUFXLWEHIRUH\RXFRQQHFW
ensure that the ignition is off.
Ensure that you connect the yellow and red
power supply leads after all other leads are
connected.
Ensure that all loose leads are insulated with
electrical tape.
Ensure that the leads do not get caught under
screws orin parts that will move (e.g. seat rail).
Ensure that all ground (earth) leads are run to
a common ground (earth) point.
Use only the supplied mounting hardware for a
safe and secure installation.
,PSURSHUIXVHVFDQFDXVHGDPDJHRUÀUH
:KHQ\RXQHHGWRFKDQJHWKHIXVHFRQVXOWD
professional.
EN
