12
Tip
The pin arrangement for the ISO connectors
•
depends on the type of vehicle you drive. Be
sure to make proper connections to prevent
damage to the unit.
Mount into the dashboard
1
If the car does not have an on-board
drive or navigation computer, disconnect
the negative terminal of the car battery.
If you disconnect the car battery in
•
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
If the car battery is not disconnected,
•
to avoid short-circuit, ensure that the
bare wires do not touch each other.
2
Ensure that car dashboard opening is
within these measurements:
183 mm
53mm
5mm
3
Remove the two screws on the top of the
unit.
2
Cut off the bigger end of the supplied
standard connector.
3
Check the car’s wiring carefully and
connect them to the supplied standard
connector.
1
Green/black strip Left speaker
(Rear)
2
White/black strip Left speaker
(Front)
3
Gray/black strip
Right speaker
(Front)
4
Purple/black strip Right speaker
(Rear)
e
RED
Ignition key +12V DC
when ON/ACC
f
BLUE
Motor/electric antenna
relay control lead/
Amplifier relay control
lead
g
BLACK
Ground
h
YELLOW To the +12V car battery
which is energized at all
times
4
Connect the supplied standard connector
to the unit.
b
a
c
d
a
a
b
c
d
a
b
e
f
c
d
g
h
b
c
d
EN
