Philips BlueTouch PR3092/04, User Manual

Page: 19 / 70

- Upper back straps are available separately under type number PR3081,
depending on your size.
Note: Do not wear multiple layers of clothing or tight or thick clothing over the
BlueTouch Pain Relief Patch to prevent the device from switching off before the
treatment has been completed. If you wear too tight or thick clothing,
the infrared sensor will measure a too high temperature and switch off the device.
Positioning the lower back strap
To place the BlueTouch Pain Relief Patch in the strap, follow the steps
below.
1 Put the lower back strap and the BlueTouch Pain Relief Patch in front
of you on a table. Slide the left side of the BlueTouch Pain Relief
Patch behind the elastic edge of the opening in the strap.
2 Then slide the other end of the BlueTouch Pain Relief Patch behind
the opposite elastic edge of the opening so that the whole patch is
inside the lower back strap. Check to make sure that the LEDs are
not covered by the material of the strap. If necessary,
shift the BlueTouch Pain Relief Patch a little.
3 Remove clothing from the area to be treated.
Note: Make sure the skin in the area to be treated is clean, entirely dry and
free from creams, lotions and other cosmetics.
4 Wrap the lower back strap with the BlueTouch Pain Relief Patch in it
around your waist with the opening of the strap facing your back.
5 Fasten the lower back strap with the Velcro strips on both ends of
the lower back strap.
Note: Make sure the BlueTouch Pain Relief Patch in the strap is located on the
area to be treated and the LED area is in contact with the skin.
Positioning the upper back strap
1 To put the BlueTouch Pain Relief Patch in the upper back strap,
follow the same procedure as described in steps 1 and 2 in section
‘Positioning the lower back strap’ above.
ENGLISH
19