POWER SUPPLY
5
Whenever convenient, use the power supply if you want to
conserve battery life. Make sure you remove the plug from the
set and wall socket before inserting batteries.
BATTERIES (OPTIONAL)
1.
Open the battery compartment and insert six batteries, type
R-14
,
UM-2
or
C-cells
, (preferably alkaline) with the correct
polarity as indicated by the "+" and "-" symbols inside the
compartment.
Remote control (supplied)
Open the battery compartment and insert two batteries,
type
AAA
,
R03
or
UM4
(preferably alkaline).
2.
Replace the compartment door, making sure the batteries are
firmly and correctly in place. The set is now ready to operate.
– Incorrect use of batteries can cause electrolyte leakage and
will corrode the compartment or cause the batteries to burst.
Therefore:
–
Do not mix battery types
, e.g. alkaline with carbon zinc.
Only use batteries of the same type for the set.
– When inserting new batteries, do not try to mix old
batteries with the new ones.
– Remove the batteries if the set is not to be used for a long
time.
Note:
The battery supply is switched off when the set is
connected to the mains.
Batteries contain chemical substances, so they should be
disposed of properly
For users in the U.K.: please follow the instructions on page 2.
Using the AC MAINS
1.
Check if the mains voltage
as shown on the type plate
located on the base of the set
, corresponds to your local
power supply. If it does not, consult your dealer or service
centre.
2.
Connect the mains lead to the MAINS socket and the wall
socket. The power supply is now connected and ready for use.
3.
To switch off completely, withdraw the mains lead from the
wall socket.
– Disconnect the mains lead from the wall socket to protect your
set during heavy thunderstorms.
AZ 1120 /00
page
5
English
MAINS
6 x R14/UM-2/C-CELL
2 x AAA/R03/UM4
XP AZ 1120/00-1 22-06-2000 15:08 Pagina 5
