background image

6

Cassette playback

1

Push the 

Source selector

to 

TAPE 

2

Press 

STOP

EJECT

9/

to open the 

cassette holder and insert a cassette and close
the deck.

3

Press 

PLAY 

1

to start playback.

4

To pause playback press 

PAUSE 

;

.

To resume, press the key again.

5

By pressing 

F.FWD/REWIND 

or

6

,

fast forwading/ rewinding of the tape is 
possible in both directions. To stop fast 
winding, press 

9

/

/

.

6

To stop the tape, press 

9

/

/

.

Helpful hints:

During playback, the keys are automatically
released at the end of a tape and the set is
switched off (unless

PAUSE 

;

mode has been

activated.)

During fast forwarding/rewinding, the keys will
not  be released at the end of a tape. To switch
off the set, make sure the cassette keys are
also released.

General information on recording

Recording is permissible insofar as copyright
or. other rights of third parties are not
infringed.

For recording, use only NORMAL type cas-
settes (IEC type I) on which the tabs have
not yet been broken.This deck is not suited
for recording on CHROME (IEC II) or
METAL (IEC IV) type cassettes.

The best recording level is set automatically.
Altering the 

VOLUME

will not affect the

recording.

To protect a tape from accidental erasure,
break out the tabs. If you wish to record again,
cover the tabs with a piece of adhesive tape.

Recording from the Radio

1

Select 

RADIO

source.

2

Tune to the desired radio station (see 

Radio

reception

).

3

Press 

9

/

/

to open the cassette holder.

Insert a blank tape and close the deck.

4

Press

REC 

0

to start recording.

5

For brief interruptions press 

;

.

To resume recording, press 

;

again.

6

To stop recording, press 

9

/

/

.

Making your recording

1

Select 

TAPE

source.

2

Follows steps 3-4 under 

Recording from

the Radio

.

3

Speak towards the built-in microphone 

MIC

(see 

1

).

4

Follows steps 6-7 under 

Recording from

the Radio

.

Cassette Recorder

The making of unauthorized copies of
copy-protected material, including com-
puter programmes, files, broadcasts and
sound recordings, may be an infringe-
ment of copyrights and constitute a
criminal offence.This equipment should
not be used for such purposes.

AQ5120_61 IFU  29/11/05  15:10  Page 6

Summary of Contents for AQ5120











Reviews: