INSTALLATION
POWER SUPPLY
1
Check if the power supply, as shown on the
type plate located on the bot-
tom of the set
, corresponds to your local power supply. If it does not, consult
your dealer or service center.
2
Connect the power cord to the wall outlet.
3
To disconnect the set from the power supply completely, remove the
plug from the wall outlet.
CLOCK MEMORY BACKUP
The clock memory backup allows your alarm and clock time settings to be stored
for up to a day when there is a power interruption e.g. power failure. The com-
plete clock radio and display illumination will be switched off. As soon as the
power supply returns, the display will indicate the correct time.
1
Remove the battery door to insert a
9 volt 6F22
type battery (not included) for
backup.
2
Replace the battery door.
NOTE:
If no backup battery is installed or the power interruption is prolonged, you
will need to set the clock and alarm time again.
For users in the U.K., please follow the boxed instructions ‘Important
notes...’ on this sheet.
Batteries contain chemical substances, so they should be disposed
of properly.
Standby power consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1W
