Philips ACT200, Service Manual

Page: 4 / 34

1 - 3
Windows system requirements
you need to have a usb port. computers that were upgraded from Win 95 to Win 98
may not have usb compatibility! check out the other requirements:
– Pentium® MMX 166MHz processor or better
– usb port with Windows 98 / Me / 2000 / XP
– 64MB(for ACT200), 96MB(for ACT210) ram
– 50MB ram drive space
– cd rom drive
– video display card
– sound card
– Microsoft Internet Explorer 5.0 or better , Netscape 4.0 or better, and internet
access
Mac system requirements
– G3 or better
– MacOS 8.6-9.X
minium computer system requirements
INSTRUCTION FOR USE
psa[64 and psa[128 is a solid-state, portable, digital audio player:
– plays mp3 & windows media audio files e.g. digitized and compressed cd tracks,
tape tracks, audio books, newspapers, sound effects, etc., that are encoded into
mp3 & windows media audio format.
– software upgradeable and will support future playback formats and sofware exten-
sions that will be made available on www.nike-philips.com .
– will support for future digital rights management technology, including the Secure
Digital Music Initiative (SDMI).
take care when using headphones
hearing safety: listen at a moderate volume. using headphones at high volume can
impair your hearing.
traffic safety: do not use headphones while driving or cycling as you may cause an
accident.
general maintenance
to avoid damage or malfunction:
– do not expose to excessive heat caused by heating equipment or direct sunlight.
– do not drop the psa or allow objects to fall on the psa.
– do not allow the psa to be submersed in water. do not expose earphone socket or
battery compartment to water as water entering the set may cause major damage.
– do not use any cleaning agents containing alcohol, ammonia, benzene, or abrasi-
ves as these may harm the set.
– active mobile phones in the vicinity may cause interference.
general information
battery
1 press
4
to open the battery cover latch and insert
one AAA battery preferably alkaline, or Ni-MH as
indicated.
2 insert the lower edge of door as shown to close
the battery cover latch.
IMPORTANT!
– remove the battery if: battery drained or the
psa will not be used for more than two weeks.
– batteries contain chemical substances, so they
should be disposed of properly .
indication of empty battery (for ACT210)
the number of blocks inside the battery icon
indicates the battery power remaining. when the
battery is low, the battery icon flashes. if no action
is taken to renew the battery, the display shows
BAT LOW ! 5 seconds later the psa automatically
switches off.
power supply
P
o
r t
a b
l e
S p o
r t A u d i o b
y
P h
i l i
p
s
(for ACT200)
beep beep! indication of empty battery
when the power level is almost empty , the psa64
will beep at intervals and the inidicator lights up
red. the psa will eventually switch itself off.
always replace the battery after the first battery
warning beep is heard.
battery charger* (for ACT210)
1
open the battery compartment. insert the batteries
as indicated.
2
plug charger to wall outlet. the battery charger
indicator lights up red when charging. a green light
indicates charging has finished. maximum charging
time: approx. 4 hours.
note : always disconnect the battery charger from
the power outlet if you do not need to use it. batte-
ries cannot be charged onboard the
psa[128 max.
* not supplied with Asia-Pacific versions
power supply