Philips AC1382, User Manual

Page: 37 / 44

E
ngl
ish
8 Troubleshooting
This chapter summarizes the most common problems you could encounter with the air
purifier. If you are unable to solve the problem with the information below, visit www.
philips.com/support or contact the Consumer Care Center in your country.
Problem Possible solution
The air purifier
cannot be
switched on.
• Make sure the front cover is properly attached to the air
purifier.
The air purifier
does not work
even though it is
plugged in to the
wall outlet and
switched on.
• The timer is set to a specific time interval. Reset or turn off
the timer.
• Try a different electrical outlet or check the wall switch.
•
The filter alert status is displaying the filter code. Replace
the corresponding filter and reset the filter lifetime counter
(see chapter "Replacing the filter").
• If the problem persists, contact the Consumer Care Center
in your country.
The air purifier
does not work
even though it is
switched on. • The filter replacement indicator has been on continuously
but you have not replaced the corresponding filter, and the
air purifier is now locked. In this case, replace the filter and
reset the filter lifetime counter.
The air purifier
accidentally
powers off.
• The air purifier restarts automatically and goes to the
previous mode when the power resumes.
The airflow that
comes out of
the air outlet
is significantly
weaker than
before.
•
The pre-filter is dirty. Clean the pre-filter (see chapter
"Cleaning").
The air quality
does not improve,
even though the air
purifier has been
operating for a
long time.
• One of the filters has not been placed in the air purifier or
the filter is not placed properly. Make sure that all filters
are properly installed in the following order, starting with
the innermost filter: 1) NanoProtect filter Pro S2 (
FY1417
);
2) pre-filter.
• The air quality sensor is wet. Make sure that the air quality
sensor is clean and dry (see chapter "Cleaning").
37 EN