Directions for Use
GB 5
A10PTV2.0 NTSC
3.
3. Directions for Use
4. Mechanical Instructions
4.1
Disassembly Procedures
All numbers found in the following text refer to the
CABINET DISASSEMBLY EXPLODED VIEW drawing and
apply to all models.
NOTE: If you are only servicing a PCB or speaker, you do not
have to remove the plastic upper back cover.
Figure 4-1
4.1.1
Removal of Upper Back Cover (2)
1. Remove 8 screws (A).
2. Remove 3 screws (B).
3. Lift cover up to dislodge from pegs (J) and remove cover.
4.1.2
Removal of Lower Center Back Cover (1)
1. Remove 3 screws (B).
2. Remove 8 screws (C).
4.1.3
Removal of Mirror Mounting Board (18)
1. Remove 6 screws (D) located in the mirror mounting
board and remove the board.
NOTE:
Care should be taken NOT to place fingerprints or
smudges on mirror.
4.1.4
Removal of Plastic Light Barrier (16)
1. Remove two screws (E) located at the sides of the Plastic
Light Barrier.
4.1.5
Removal of Side Back Covers (3)
NOTE:
To gain access to the Side Jack Panel
(D)
and two
Speakers, remove the Left Side Back Cover.
To gain access to the AC Power Switch Panel
(L)
, remove
the Right Side Back Cover.
1. Remove 4 screws (F) from each of the Side Back Covers.
4.1.6
Removal of Large Signal Panel (A)
1. Pull 3 tabs on right of bracket and 2 tabs on left of
bracket.
2. Lift Large Signal Board up and out.
4.1.7
Removal of PFC Filter Panel (G)
1. Remove 4 screws from CBA.
2. Lift PFC Filter Panel up and out.
4.1.8
Removal of Small Signal Panel (C)
1. Remove 2 screws from the middle of the CBA.
2. Pull 3 tabs on right of bracket.
!
CABINET DISASSEMBLY EXPLODED VIEW
16
PHILIPS
PHILIPS
30
2
A
A
3
1
Left
Right
B
C
F
F
27
22
18
D
Optical Assembly
H
G
G
6
E
E
J
CL 06532143_003.eps
011100
