ENGLISH
23
ENGLISH
22
◗
During the first few minutes of the cleaning
cycle, the razor will automatically turn on and
off several times while the razor holder
lowers and raises the razor’s position in the
cleaning solution, removing all debris.
◗
After approximately 5 minutes, the razor
holder will be raised slightly and will stay in
this position for about 55 minutes.The
cleaning light will remain blinking until the
entire process is complete.
◗
Do not lift the razor lever or press the
ON/OFF button while the cleaning cycle is
running. If this does occur, the cleaning cycle
will stop and the razor holder will
automatically move to the highest position.
The cleaning cycle can be re-started by
pressing the ON/OFF button once.
◗
If the power plug is disconnected before the
cleaning cycle is complete, the razor holder
will remain in its current position. Reconnect
the plug into the outlet or Jet Clean System
and the razor holder will automatically
move to the highest position. The cleaning
cycle can be re-started by pressing the
ON/OFF button once.
C
6
When the entire cleaning cycle is complete
and the razor is hygienically clean, the razor
will be raised to the highest position and
the cleaning light on the Jet Clean System
will light up continuously.
C
7
Raise the lever holding the razor to the
highest position (1) and carefully remove
the razor from the Jet Clean System (2).
◗
You may quickly rinse the razor heads with
warm water after using the Jet Clean System
to remove any residual cleaning solution.
◗
If the razor needs to be recharged, you can
simply leave it in the Jet Clean System after
cleaning and the razor will automatically
recharge.The charging light on the Jet Clean
System will blink to indicate the razor is
recharging.
◗
For optimal razor drying time after cleaning,
remove razor from Jet Clean System after the
cleaning cycle is complete and allow to air dry.
◗
You may store your razor in the Jet Clean
System. Unplug from the outlet when
charging/cleaning is complete.
Quick Cleaning: Razor Heads
The razor heads may also be quickly cleaned
after each use by rinsing with hot water. Water
from the tap should be on a hot setting, BUT BE
CAREFUL TO TEST WATER FIRST SO AS NOT
TO BURN OR SCALD HANDS.
◗
Regular cleaning guarantees better shaving
results.
◗
Do not immerse razor in water.
C
◗
The tap symbol on the back of the razor
indicates that the razor can be rinsed under
running tap water.
C
◗
While rinsing razor heads, water may drip out
of the base of razor.This is a normal occurrence.
1
Always turn razor OFF, unplug from outlet
and remove cord from razor before
cleaning.
