frequency value to search for channels,
select
Advanced
.
Frequency step size
The TV searches for channels in steps of
8MHz
.
If this results in having no channels installed or if
some channels are missing, you can search in smaller
steps of
1MHz
. Using the 1MHz steps will take more
time to search for and install channels.
Network frequency mode
If you intend to use the fast
Quick
method
in
Frequency scan
to search for channels,
select
Automatic
. The TV will use 1 of the predefined
network frequencies (or HC - homing channel) as
used by most cable providers in your country.
If you received a specific network frequency value to
search for channels, select
Manual
.
Network frequency
With the
Network frequency mode
set to
Manual
,
you can enter the network frequency value received
from your cable provider here. To enter the value,
use the number keys.
Network ID
Enter the network ID supplied by your cable
provider.
Symbol rate mode
If your cable provider did not give you a
specific
symbol rate
value to install the TV channels,
leave the
Symbol rate mode
setting on
Automatic
.
If you received a specific symbol rate value,
select
Manual
.
Symbol rate
With the
Symbol rate mode
set to
Manual
, you can
enter the symbol rate value by using the number
keys.
Digital: Reception Test
(Home) > Settings > Install
Channels >
Antenna installlation
>
Digital:
reception test
The digital frequency is shown for this channel. If the
reception is poor, you can reposition your antenna.
To check the signal quality of this frequency again,
select
Search
and press
OK
.
To enter a specific digital frequency yourself, use the
remote control digit keys. Alternatively, select the
frequency, position the arrows on a number
with
and
and change the number
with
and
. To check the frequency,
select
Search
and press
OK
.
Analogue: Manual Installation
(Home) > Settings > Install
Channels >
Antenna installlation
>
Analogue:
manual installation
Analogue TV channels can be manually installed,
channel by channel.
•
System
To set up the TV system, select
System
.
Select your country or the part of the world where
you are now and press
OK
.
•
Search Channel
To find a channel, select
Search Channel
and
press
OK
. You can enter a frequency yourself to find
a channel or let the TV search for a channel.
Press
OK
, select
Search
and press
OK
to search
for a channel automatically. The found channel is
shown on screen and if the reception is poor,
press
Search
again. If you want to store the channel,
select
Done
and press
OK
.
•
Fine tune
To fine tune a channel, select
Fine tune
and
press
OK
. You can fine tune the channel
with
or
.
If you want to store the channel found,
select
Done
and press
OK
.
•
Store
You can store the channel on the current channel
number or as a new channel number.
Select
Store
and press
OK
. The new channel
number is shown briefly.
You can redo these steps until you have found all
available analogue TV channels.
Channel List copy
Introduction
Channel list copy
is intended for dealers and expert
users.
With
Channel list copy
, you can copy the channels
installed on one TV onto another Philips TV of the
same range. With
Channel list copy
, you avoid the
time-consuming channel search by uploading a
predefined channel list on a TV. Use a USB flash drive
of minimum 1 GB.
Conditions
• Both TVs are from the same year range.
• Both TVs have the same hardware type. Check the
hardware type on the TV type plate on the back of
16