Mechanical Instructions
4.
4.5.6
IR/LED Board
Refer to
for details.
1.
Remove the fixation screw [1] from the
bracket, pull out the
assy from the set.
2.
Carefully Releas the cover secured by clips, then unplug
the connector [2] from the IR/LED board. The IR/LED
Board can now be lifted and taken out from the cover.
Figure 4-26 IR/LED Board removal
4.5.7
Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1.
Unplug all connectors from the PSU.
2.
Remove all fixation screws from the PSU.
3.
The PSU can be taken out of the set now.
4.5.8
Speakers
1.
Gently release the tapes that secure the speaker cables.
2.
Unplug the speaker connector from the SSB.
3.
Take the speakers out.
When defective, replace the both units.
4.5.9
WIFI module
1.
Unplug the connector from the SSB.
2.
Remove fixation screw that secure the WIFI module,
getntly remove the module from the set.
When defective, replace the whole unit.
4.5.10 LED Logo Board
for details.
1.
Remove from the fixation area[1] on the bracket, pull out
the assy from the set.
2.
Carefully Releas the cover secured by clips, then unplug
the connector [2] from the LED Logo board. The LED Logo
board can now be lifted and taken out from the cover.
Figure 4-27 LED Logo Board removal
4.5.11 LCD Panel
1.
Remove the SSB as described earlier.
2.
Remove the PSU as described earlier.
3.
Remove the keyboard control panel as described earlier.
4.
Remove the stand bracket as described earlier.
5.
Remove the IR/LED as described earlier.
6.
Remove the WIFI module as earlier.
7.
Remove the fixations screws that fix the metal clamps to
the front bezel. Take out those clamps.
8.
Remove all other metal parts not belonging to the panel.
9.
Lift the LCD Panel from the bezel.
When defective, replace the whole unit.
4.6
Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
•
While re-assembling, make sure that all cables are placed
and connected in their original position. See
•
Pay special attention not to damage the EMC foams on the
SSB shields. Ensure that EMC foams are mounted
correctly.
20152_107.eps
2
Step 1
Step 2
Step 3
1
20152_108.eps
2
1
1
