Mechanical Instructions
4.
4.6.4
Speakers
1.
Unplug the speaker connectors from the SSB.
2.
Remove all the fixation screws that secure the speakers.
3.
Gently release the tapes that secures the speaker cables.
4.
Take the speakers out.
When defective, replace the both units.
4.6.5
Stand bracket
1.
Remove all fixation screws of the bracket.
2.
Lift the bracket from the set.
4.6.6
IR/LED Panel
1.
Remove the stand bracket, as described earlier.
2.
Unplug the connector from the IR/LED panel.
3.
Gently release the clip that holds the panel and take it out
from the bezel.
When defective, replace the whole unit.
4.6.7
LCD Panel
1.
Remove the SSB as described earlier.
2.
Remove the PSU as described earlier.
3.
Remove the keyboard control panel as described earlier.
4.
Remove the stand bracket as described earlier.
5.
Remove the IR/LED as described earlier.
6.
Remove the fixations screws that fix the metal clamps to
the front bezel. Take out those clamps.
7.
Remove all other metal parts not belonging to the panel.
8.
Lift the LCD Panel from the bezel.
When defective, replace the whole unit.
4.7
Assembly/Panel Removal( for 40"/50" 4500
series)
Instructions below apply to the 40PFK4509/12, but will be
similar for other 40"/50" 4500 series models.
4.7.1
Rear Cover
for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1.
Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
screws [2], [3] that secure the rear cover. Refer to
2.
Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
Figure 4-30 Rear cover removal
19603_114.eps
1
M4 × 10
Q3 × 8
1
1
1
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
1
M3 × 6
3
3
