5.8 3D
3D
This TV is prepared for the 3D Full HD accessory PTA02 (sold
separately -
only for 40-46PFL8505/8605 and 52PFL8605).
PTA02 Installation
1
Switch off the TV.
2
Connect the 3D transmitter to the 3D connection
3D Out
on
the back of the TV.
3
Install the 3D transmitter on the top or at the bottom of the
TV. Make sure to point the transmitter directly to where you sit
to watch TV.
The small window in the middle of the glasses receives the 3D
signals from the transmitter.
Update the TV software
To prepare your TV for 3D watching, you must update the TV
software.
1
Switch on the TV.
2
Plug in the USB device in the
USB
connection at the side of
the TV.
3
The software update will start automatically and during the
update the TV might switch off and on again. Do not press any
key on the remote control and wait until the message ‘Operation
Successful’ appears.
4
Unplug the USB device and switch the TV off and back on
again.
Your TV is ready to watch 3D.
Connections / 3D
69
