Mechanical Instructions
EN 18
4.
4.2
Service Positions
For easy servicing of a TV set, the set should be put face down
on a soft flat surface, foam buffers or other specific workshop
tools. Ensure that a stable situation is created to perform
measurements and alignments. When using foam bars take
care that these always support the cabinet and never only the
display. Caution: Failure to follow these guidelines can
seriously damage the display!
Ensure that ESD safe measures are taken.
4.3
Assy/Panel Removal
4.3.1
Rear Cover
Warning: Disconnect the mains power cord before removing
the rear cover.
Attention: All sets are equipped with a hatch to disconnect the
keyboard control panel. Ambilight sets are in addition equipped
with a hatch to disconnect the Ambilight units.
These hatches are indicated on the rear cover with
SERVICE
h
.
It is mandatory to open the hatches and disconnect the
cables prior to removal of the rear cover!
See
for details.
1.
For sets equipped with Ambilight: open the hatch that
covers the Ambilight connector and unplug the connector
[1].
2.
Remove the hatch that covers the keyboard control panel
connector by removing the screws [3].
3.
For sets equipped with Ambilight: remove the stand and
swivel block [4].
4.
Unplug the keyboard control panel connector located
underneath the keyboard control hatch.
5.
Remove remaining fixation screws.
6.
Lift the rear cover from the TV. Make sure that wires and
flat foils are not damaged while lifting the rear cover from
the set.
Figure 4-18 Rear cover removal -all models -1-
Figure 4-19 Rear cover removal -all models -2-
4.3.2
SSB
Refer to
Some SSBs have a dedicated LVDS connector, requiring
pressing two catches as indicated in the figure, before
removing the LVDS cable.
Figure 4-20 SSB LVDS connector catches (optional) -1-
Upon re-connecting the LVDS cable, ensure the catches are
locked after having inserted the LVDS cable.
19300_053_120418.eps
120418
1
19300_054_120418.eps
120418
3
3
4
4
4
3
19054_001_111010.eps
111010