Mechanical Instructions
4.
Figure 4-7 IR/LED Board removal
4.3.6
Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1.
Gently unplug all connectors from the PSU.
2.
Remove all fixation screws from the PSU.
3.
The PSU can be taken out of the set now.
4.3.7
Stand bracket
1.
Remove all fixation screws of the bracket.
2.
Lift the bracket from the set.
4.3.8
LCD Panel
1.
Remove the SSB as described earlier.
2.
Remove the PSU as described earlier.
3.
Remove the keyboard control panel as described earlier.
4.
Remove the stand bracket as described earlier.
5.
Remove the IR/LED as described earlier.
6.
Remove the fixations screws that fix the metal clamps to
the front bezel. Take out those clamps.
7.
Remove all other metal parts not belonging to the panel.
8.
Lift the LCD Panel from the bezel.
When defective, replace the whole unit.
4.4
Assembly/Panel Removal
Instructions below apply to the 32HFL3011T/12, but will be
similar for other 32"/40"HFL
3
011T series models.
4.4.1
Rear Cover
Warning: Disconnect the mains power cord before removing
Figure 4-8 Rear cover removal
20210_109.eps
3
Step 1
Step 2
2
2
1
20140_103.eps
2
2
2
2
2
2
2
2
2
2
2
2
2
2
1
1
1
1
3
3
