Philips 32PFG5509/78, Service Manual

Page: 15 / 98

Mechanical Instructions EN 15 TPM14.2L LA 4.
2014-Feb-28
back to
div. table
4.3.5 Speakers
1. Gently release the tapes that secures the speaker cables.
2. Unplug the speaker connectors from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4.3.6 Stand bracket
1. Remove all fixation screws of the bracket.
2. Lift the bracket from the set.
4.3.7 IR/LED Panel
1. Remove the stand bracket, as described earlier.
2. Remove fixation screw that secure the deco rear cover and
take it out from the deco.
3. Unplug the connector from the IR/LED panel.
4. Gently release the double faced adhesive tape that pasted
the panel and take it out from the deco.
When defective, replace the whole unit.
4.3.8 WIFI module
1. Unplug the connector from the SSB.
2. Remove fixation screw that secure the WIFI module,
getntly remove the module from the set.
When defective, replace the whole unit.
4.3.9 LCD Panel
1. Unplug all the connector cables of the boards.
2. Gently take all the speakers out.
3. Lift the subframe with SSB, PSU, panel from the LCD panel
and put it aside.
Warning: Cause the panels of 32"/40"/48"PxG5509/78 are
bolt-on panels, the panel could not release from bezel.
When defective, replace the whole unit.
4.4 Assembly/Panel Removal ( for
40"/42"/47"/48"PFG5909/6309/6809/6519
series)
Instructions below apply to the 42PFG6809/78, but will be
similar for other 40"/42"/47"/48"PFG5909/6309/6809/6519
series models.
4.4.1 Rear Cover
Refer to Figure 4-10 for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1.
Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
screws [2], [3] that secure the rear cover. Refer to
Figure 4-10 for details.
2. Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
Figure 4-10 Rear cover removal
4.4.2 Keyboard Control Unit
Refer to Figure 4-11 for details.
1. Release the connector [2] from the keyboard control panel.
Caution: be careful, as these are very fragile connectors!
2. Remove all the fixation screws from the keyboard control
panel [1].
When defective, replace the whole unit.
19640_109.ep s
1
M4 × 10
Q 3 × 8
1 1
1
2
2 2
2
2
2
2
2
2
2
2
2
2 2
2
1
3
M 3 × 4
3