27
Connect Peripheral Equipment
Connect Extra loudspeakers / Amplifier
To the connector clips
To the output S
R
L
REAR
AUDIO
S
or
REAR multimedia loudspeakers
You can enjoy Dolby Pro Logic Surround sound by connecting two rear
loudspeakers to be connected or to the connector clips or to the Dolby
Surround output S at the back of your TV.
&
Connect two Surround Sound rear loudspeakers (min. 16
Ω
)
to the connector clips at the back of the TV. Always connect
both Surround Sound loudspeakers: the left rear loudspeaker
at
REAR L
; the right rear loudspeaker at
REAR R
.
Push the connector clip down and insert the end of the wire into
the opening: the positive wire (the one with the black line) to the
red loudspeaker connection; the negative wire to the black
loudspeaker connection. Do not insert the wires too far.
The Surround Sound loudspeakers should always be located
behind or to either side of the listener. If preferred you can also
hang the loudspeakers on the wall.
é
Select
Rear speakers Yes
in the Setup menu. See p. 7.
See Surround settings, p. 14 for the available Surround
modes.
Rear Surround Sound loudspeakers should always be located
behind or to either side of the listener at about 1 m above
the seated listener’s head.
“
Adjust the volume of the rear loudspeakers.
You may make use of the Test tone function in the Surround
settings menu, see p. 13, to have a reference of the loudness
of the separate loudspeakers.
Note: Once you have adjusted the volume of the rear
loudspeakers, do not change it while watching TV as the whole
configuration operates with the volume adjustment of your TV.
&
Connect two rear loudspeakers with built in amplifiers (or
an audio amplifier with rear loudspeakers).
Connect the audio cables to the rear loudspeakers and to
the Dolby surround output
S
at the back of your TV as
shown above.
There is only one cinch output for both speakers. Use a
mono to stereo adaptor.
Note: Switch off the TV and the rear loudspeakers before
connecting them.
é
Select
Rear speakers Yes
in the Setup menu. See p. 7.
See Surround settings, p. 14 for the available Surround
modes.
Rear Surround Sound loudspeakers should always be located
behind or to either side of the listener at about 1 m above
the seated listener’s head.
“
Adjust the volume of the rear loudspeakers.
You may make use of the Test tone function in the Surround
settings menu, see p. 13, to have a reference of the loudness
of the separate loudspeakers.
Note: Once you have adjusted the volume of the rear
loudspeakers, do not change it while watching TV as the whole
configuration operates with the volume adjustment of your TV.
4890.1 gb 05 kopie 12-01-2000 11:46 Page 27
