Mechanical Instructions
4.
4.3.3
Speaker
Refer to
for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1.
Remove the fixation screws [1] that secure the rear cover.
Refer to
2.
Release the connectors [2] and [3] that connect speake
with the SSB. Refer to
for details.
3.
Gently lift the Speaker from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
Figure 4-4 Speaker removal
4.3.4
Small Signal Board (SSB)
Refer to
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1.
Release the clips from the LVDS connector that connect
with the SSB[1].
Caution: be careful, as these are very fragile connectors!
2.
Unplug all other connectors [2] .
3.
Remove all the fixation screws from the SSB [3].
4.
The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket. Refer to
Figure 4-5 SSB removal
20100_103.eps
1
Q4 × 12
1
1
2
3
20100_104.eps
2
1
3
3
3
3