!
92 Meridian 3
5.9 If paint is used
y
RoHS required
y
WEEE require
y
If new painting type needs to implement, refer to UN-D 1235.
5.10 Plastic mold tooling
y
Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines,
gate marks, ejector marks, etc.). Refer to “TYV61-90007”.
y
Painting to cover up cosmetic defects due to molding is strongly discouraged.
y
China RoHS mark requested.
5.11 Plastics flammability
y
All Plastics to be Flame Retardant UL 94-HB or better.
y
Base / Rear to be Flame Retardant UL 94-HB.
y
All major plastic parts (bezel, back cover) need to be molded from same resin.
y
Plastic resin type selection should be referred to “plastic-Philips Pool monitor”.
5.12 Texture/Glossing of housing
y
The texture area and texture no should follow Philips make-up sheet.
y
The exterior surfaces shall have a uniform texture.
y
Philips must approve the mold texturing.
y
Detail document for texture refer to “UN-D249”, “UN-D 600”.
y
>= 80 gloss units
5.13 Tilt and swivel base
y
Tilt angle:
-5
q
+2/- 0
q
(forward)
+20
q
+ 3/- 0
q
(backward)
y
Swivel
Angle
nil
y
High Adjustment
nil
y
Portrait Display
nil
5.14 Kensington Lock
y
Must meet Kensington_slot.spec “TYE-M0004”.
y
MMD request metal plate in Kensington hole.
5.15 Label
y
Regulatory label / Carton label should follow Philips requirement.
y
Detail document refer to Philips Engineering Reference Book.
5.16 Product dimension / Weight (Refer to Philips approved SHT 191/ SHT560)
y
Unit dimension
y
Packed unit dimension:
y
Net weight :
y
Gross weight