Mechanical Instructions
4.
4.4
Assembly/Panel removal for
22HFL3017 sets
4.4.1
Stand
Refer to
for details.
1.
Remove fixation screws [1,2] that secure the base
assembly, pull the base assembly downwards away from
the catches. Do not release the two screws in the middle of
the stand.
4.4.2
Rear Cover
Warning: Disconnect the mains power cord before removing
the rear cover.
1.
Remove fixation screws [1]and [2] that secure the rear
cover.
2.
At the top side the rear cover is locked by catches, so
gently lift the bottom side and push the cover upwards to
release these catches. Then lift the cover from the TV.
Make sure that cabling and wires are not damaged while
lifting the rear cover from the set.
Figure 4-7 Rear cover removal
4.4.3
Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1.
Unplug all connectors from the PSU.
2.
Remove the fixation screw located right side of the mains
inlet connector.
3.
Remove the other four fixation screws located at the
corners of the panel.
4.
The PSU can be taken out of the set now.
When defective, replace the whole unit.
4.4.4
Small Signal Board (SSB)
Refer to
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1.
Release the clips from the LVDS cable connector that
connects the panel to the SSB [1].
Caution: be careful, as these are very fragile connectors!
2.
Release the clamps and unplug all other connectors [2].
3.
Remove all the fixation screws from the SSB [3].
4.
Take out the SSB with I/O bracket.
5.
The SSB can now be shifted away[4] from side connector
cover and lifted from the set.
19380_105_120905.eps
120924
2
M4 × 2
3 × 8
1
2
2
1
1
1
1
1
1
