Philips 170C4FS/00, Service Manual

Page: 8 / 66

170C4/N4
8
Go to cover page
Warning message table
Warning message table
Attention Signals Display Time Condition
CANNOT DISPLAY THIS VIDEO
MODE, CHANGE COMPUTER
DISPLAY
INPUT TO 1280x1024 @ 60HZ
30 mins This warning appears when the input signal
from your computer is not in a standard video
mode or is out of the monitor’s scanning
range. After 30 mins, monitor enters sleeping
mode.
NO VIDEO INPUT 30 mins This message appears when there is no
signal input while power on. After 30 mins,
monitor enters sleeping mode.
CHECK CABLE CONNECTION 30 mins This message appears when a signal cable is
disconnected while monitor is working. After
30 mins, monitor enters sleeping mode.
ENTERING SLEEP MODE 3 secs This message appears when monitor is about
to enter power saving mode.
WAITING FOR AUTOMATIC
ADJUSTMENT till auto
adjustment
finished This message is displayed when the auto
adjustment button is pressed. It disappears
when automatic adjustments are completed.
USE 1280x1024 FOR BEST RESULT On top of OSD
main menu
The message will show up at the top of the
OSD main menu in red color when the input
resolution is not the
1280x1024 .
OSD MAIN CONTROLS LOCKED 3 secs / or Till
"OSD MAIN
CONTROLS
UNLOCKED"
appear This message will appear 3 seconds to
indicate the OSD MAIN CONTROLS status
when to lock or un-lock it by pressing
“MENU(OK)” button for more than 10 seconds
while there is video input from PC. This
function provides the alternative that user can
lock all the OSD main control in case user
don’t want the FOS performance setting to be
changed, for instance, during commercial
exhibition.
OSD MAIN CONTROLS UNLOCKED 3 secs This message will appear 3 seconds to
indicate the OSD MAIN CONTROLS status
when to un-lock it by pressing “MENU(OK)”
button for more than 10 seconds while there
is video input from PC.
ATTENTION SIGNAL ON
ATTENTION SIGNAL OFF
2 secs
3 secs
This message will appear 3 seconds to
indicate the attention signals in ON or OFF
status when to switch this function on or off
by pressing the AUTO button for more than
10 seconds while at no video input from PC.
THIS IS 85HZ OVERDRIVE,
CHANGE COMPUTER DISPLAY
INPUT TO 1280x1024@60HZ 10 mins This message will appear 5 seconds in every
60 seconds for 10 minutes when the input of
PC video timing is at 85Hz mode.
Remark: AUTO is still functional in this mode
the window of "OSD MAIN
CONTROLS" 60 secs This message will appear when the “OK”
button is pressed.
the window of "BRIGHTNESS" 60 secs This message will appear when the
BRIGHTNESS button is pressed.
http://www.wjel.net