2
to the instructions for your Z-Wave
TM
Certificated Primary Controller to access the
Setup function, and to Add/Remove/associate devices
Function
Description
Annotation
No node ID
The Z-Wave Controller does not allocate
a node ID to the Switch.
LED 2-second on, 2-second
off
Add (Inclusion)
1. Put your Z-Wave controller into
inclusion mode by following the
instructions provided by the
controller manufacturer.
2. Pressing Include button of PAD07
three times within 2 seconds will
enter inclusion mode.
Remove
(Exclusion)
1. Put your Z-Wave controller into
exclusion mode by following the
instructions provided by the
controller manufacturer.
2. Pressing Include button of PAD07
three times within 2 seconds will
enter exclusion mode.
3. Node ID has been excluded.
0.5s On, 0.5s Off (Enter
auto inclusion)
Reset
1. Pressing Include button of PAD07
three times within 2 seconds will
enter inclusion mode.
Use this procedure only in
the event that the primary
controller is lost or
otherwise inoperable.
2. Within 1 second, press Include button
of PAD07 again for 5 seconds.
3. IDs are excluded.
0.5s On, 0.5s Off (Enter
auto inclusion)
Association
1. The PAD07 is an always listening
Z-Wave device, so associations may
be added or removed by a controller
at any time.
Or If your controller requires to have
the PAD07 send a 'node information
frame' or NIF for associations, then
pressing the On/Off button three
times within 2 seconds will cause
the PAD07 to send its NIF.
2. There are two groups for the dimmer.
Adding a node ID allocated by Z-Wave Controller means inclusion. Removing a node
ID allocated by Z-Wave Controller means exclusion.
Failed or success in including/excluding the node ID can be viewed from the Z-Wave
Controller.
LED Indication
To distinguish what mode the switch is in, view from the LED for identification.
State Type
LED Indication
Normal
Whenever we switch On and off of the PAD07 by On/Off button or RF
command, the LED will lights up when switch on; whereas LED off
when switch off.
No node ID
Under normal operation, when the Switch has not been allocated a
node ID, the LED flashes on and off alternately at 2-second intervals.
By pressing On/Off button, it will stop flashing temporarily.
Learning
When PAD07 is in learning mode, LED flashes on and off alternately
and repeatedly at 0.5 second intervals.
Manual dim level control :
To manually switch on the light, press and release the On/Off button or S1/S2 shortly
when the light is off. The light will dim from off to the level which was set before switch
off. To manually switch off the light, press and release the On/Off button or S1/S2
shortly when the light is on. To adjust the dim level, press and hold the On/Off button
or S1/S2 until the desired dim level is achieved, then release.
Programming
1. Basic Command Class / Multilevel Switch Command Class
The dimmer will respond to BASIC and MULTILEVEL SWITCH commands that are
part of the Z-Wave system. If PAD07 is included as a secured node, it will only
response to the security encapsulation command of BASIC and MULTILEVEL
SWITCH.
