Customer Careline: 0901 293 0038
Calls are charged at £1 per minute from a BT landline. Call charges from other networks may vary
Support: http://technical.philex.com
STEP FOUR
- FITTING THE TV MOUNTING PLATE
TO THE BRACKET ARM
Fit the TV mounting plate to the bracket arm as shown
below. Tighten the nut to secure the position. Finally fit
the dome caps to the screw head and nut to finish the
installation. Position the TV in the tilting angle required
and tighten the nut holding the TV mounting plate the tilt-
ing clamp.
STEP THREE
- FITTING THE TV MOUNTING PLATE
Once you have checked the compatibility of your
television, locate the fitting holes on the mounting plate
that match your televisions mounting holes.
Check which type of the supplied fitting screws fit your
television (M4 or M5 - supplied) and attach the plate
firmly to the back of your television.
STEP FIVE
- CABLE MANAGEMENT
This LCD wall mount is supplied with a plastic outer casing. This outer casing allows you to route and hide your power
and other cables along the arm of the mount. Before you fit the outer casing, run your cables along the arm and secure
to the arm using tape. Use a knife or scizzors or cut out routing holes in the plastic to allow the cables to pass through.
There are sections of plastic which have been made thinner to allow for easy cutting
Note:
TV not shown on mount for illustration purposes
v3
