EN - 8
07/2015
Copyright © 2015, Fast ČR, a. s.
ATTENTION
Move the appliance into position, level it, wait at least four hours and then connect it to a power socket.
If necessary, contact the customer service to set the door opening direction for you.
•
Check whether any cooling circulation pipes have been damaged during the installation.
•
Use the appliance only for the purposes for which it has been designed.
•
The appliance must be located on a rigid and even surface.
•
In this way you will ensure free circulation of the coolant and eff ective operation of your appliance.
•
If possible, place the appliance into a cool, well ventilated and dry room.
•
Do not locate the appliance in direct sunlight, or in a room with a high temperature, in the vicinity of any
sources of direct heat, such as heating, an oven, a stove, etc. – this would mean that the compressor would
need to work a lot harder resulting a substantially higher power consumption level.
If it is not possible to prevent the installation in the vicinity of a heat source, we recommend the insertion of an
appropriate insulating board (do not use asbestos) between the appliance and the heat source; or at least to
maintain the following minimum distances:
•
From a gas or electric stove 3 cm;
•
From a heater or oven, etc. 30 cm;
•
From another cooling appliance 2 cm.
Do not place any appliances on the appliance, which emit heat on to the appliance, such as
microwave ovens, toasters, etc.
Never cover the ventilation grill. Pull out the power plug by pulling on the plug itself, never pull on
the cord when disconnecting the appliance.
Before turning on the appliance allow it to stand in its fi nal location for 12 hours, the coolant circuit will stabilise
in this way and no operating problems will occur. Before connecting the appliance to the power grid, check
that it is perfectly dry inside – especially in the corners.
DANGER WARNING
The coolant may be highly fl ammable, depending on its composition. The coolant circuit was
hermetically closed and sealed and was tested many times for possible leaks. Any unqualifi ed tampering
with the product may cause a fi re hazard. Check that there is no mechanical interruption or eff ect on the
coolant circulation, namely in the accessible parts around the compressor.
Only professionally qualifi ed persons may work on the cooling system.
Cleaning before use
Check that you have removed from the appliance all adhesive tape used to hold accessories . Then clean all the
inside parts using lukewarm water with a neutral cleaning agent, vinegar or sodium carbonate – in this way
you will remove the characteristic odour of new parts – then dry carefully. Do not use detergents or aggressive
agents, which could damage the surfaces.