EN - 14
02/2015
Copyright © 2015, Fast ČR, a. s.
PART 5: MAINTENANCE AND CLEANING
WARNING!
Before cleaning, regular or other maintenance, installation or removal, check that the appliance is turned off and
disconnected from the power socket or that the respective circuit breaker is turned off .
Changing a light bulb
1. Open the separating cover/glass.
2. Take out the aluminium fi lters.
3. Disconnect the wires from the LED light bulb.
4. Push on the light bulb to remove it.
5. Remove the tape between the light bulb and the range hood.
6. Remove the protective tape from the new light bulb and proceed in reverse order to install it.
NOTE:
Do not hold the light bulb with your bare hands. Dirt or sweat from the hand may shorten their lifetime.
Cleaning
• Aluminium
fi lters capture dust and fat from the extracted air.
•
It is necessary to regularly wash these fi lters, ideally once a month, depending on the level of use. Wash the
fi lters in water with dishwashing detergent, or you may place the fi lters in a dishwasher and wash them
using a gentle program (max. 60 °C).
•
Take out the aluminium fi lters by pressing the clip.
•
After cleaning allow the aluminium fi lters to dry thoroughly before reinstalling them.
•
Wipe the outer surface of the range hood with a clean damp wiping cloth lightly dipped in water with
a small amount of dishwashing detergent. Then wipe dry.
•
Avoid electrical parts coming into contact with water or another liquid.
Cleaning the aluminium fi lters
The aluminium fi lters need to be cleaned when "C" appears on the display (depending on the model).
Clean the fi lters according to the above mentioned instructions and after reinstalling them press and hold
down the fan button for 3 seconds until the "C" symbol (depending on the model) disappears from the display.
The symbol "E" (depending on the model) will appear on the display, which means that the appliance is ready
for operation.
If you wish to use the appliance without clearing the "C" symbol (depending on the model), press the fan
button to start extraction for 1 second, then the "C" symbol (depending on the model) will appear again and
the motor will continue running.
Summary of Contents for PEI 902
