EN - 25
Copyright © 2016, Fast ČR, a. s.
08/2016
NOTE:
-
Inspect the fi lters for blocking after every time the dishwasher has been used.
-
By unscrewing the coarse fi lter, you can remove the fi lter system. Remove any food remnants and clean the
fi lters under running water.
NOTE:
The entire fi lter assembly should be cleaned once a week.
Cleaning The Filter
To clean the coarse fi lter and the fi ne fi lter, use a cleaning brush. Reassemble the fi lter parts as shown in the
fi gures on the last page and reinsert the entire assembly in the dishwasher, positioning in its seat and pressing
downward.
WARNING!
When cleaning the fi lters, don’t knock on them. Otherwise, the fi lters could be contorted and the performance
of dishwasher could be decreased.
Caring for the Dishwasher
The control panel can be cleaned by using a lightly dampened cloth. After cleaning, make sure to dry it thor-
oughly. For the exterior use a good appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
Cleaning The Door
To clean the edge around the door, you should use only a soft
warm, damp cloth. To avoid penetration of water into the door
lock and electrical components, do not use a spray cleaner of any
kind.
WARNING!
≐
Never use a spray cleaner to clean the door panel as it may damage the door lock and electrical components.
≐
Abrasive agents or some paper towel should not be used because of the risk of scratching or leaving spots
on the stainless steel surface.
Protect Against Freezing
please take frost protection measures on the dishwasher in winter. Each time after washing cycles, please
operate as follows:
1. Cut
off electrical power to the dishwasher.
2. Turn
off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain water from the inlet pipe and water valve (Use a pan to catch the water)
4. Reconnect the water inlet pipe to the water valve.
5. Remove the fi lter at the bottom of the tub and use a sponge to soak up water in the sump.
