EN - 29
Copyright © 2017, Fast ČR, a. s.
06/2017
Leveling the Appliance
Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the height of the
dishwasher, making it level. In any case, the appliance should not be inclined more than 2°.
NOTE:
The maximum adjustment height of the feet is 20 mm.
How to Drain Excess Water From Hoses
If the sink is 1000mm higher from the fl oor, the excess water in hoses cannot be drained directly into the sink.
It will be necessary to drain excess water from hoses into a bowl or a suitable container that is held outside and
lower than the sink.
Water Outlet
Connect the water drain hose. The drain hose must be correctly fi tted to avoid water leaks.
Ensure that the water inlet hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, observe to use a similar drain hose..
It must be no longer than 4 metres; otherwise the cleaning eff ect of the dishwasher could be reduced.
Syphon Connection
The waste connection must be at a height of between 50cm (minimum) and 100cm (maximum) from the
bottom of the dish. The water drain hose should be fi xed by a hose clip.
Start of Dishwasher
The followings should be checked before starting the dishwasher:
1. Whether the dishwasher is level and fi xed
2. Whether the inlet valve is opened
3. Whether there is leakage at the connections of the conducts
4. Whether the wires are tightly connected
5. Whether the power is switched on
6. Whether the inlet and drain hoses are knotted
7. All packing materials and printings should be taken out from the dishwasher
ATTENTION:
After installation, please put this manual into the bags of printings.
The content of this manual is very helpful to the users.
