EN - 24
01/2016
Copyright © 2016, Fast ČR, a. s.
NOTE:
* EN 50242: This programme is the test cycle. The information for comparability test in accordance
with EN 50242, as follows:
●
Capacity: 14 setting
●
Position Upper basket: upper wheels on rails
●
Rinse aid setting: 6
●
Pl:0.49w; Po:0.45w.
Turning on the appliance
Starting a cycle wash
1
Draw out the lower and upper basket, load the dishes and push them back. It is commended to load the
lower basket fi rst, then the upper one (see the section entitled Loading the Dishwasher).
2
Pour in the detergent (see the section entitled Salt, Detergent and Rinse Aid).
3
Insert the plug into the socket. The power supply is 220-240 V AC / 50 Hz, the specifi cation of the socket is
10A 250V AC. Make sure that the water supply is turned on to full pressure.
4
Open the door, press the ON/OFF Button, and the ON/OFF light will turn on.
5
Press the program Button , the wash program will be changed as follows direction:
ECO - Glass - 90Min - Rapid - Intensive - Normal;
If a program is selected, the response light will light. Press the start / pause button and the dishwasher will
start.
Changing the program...
Premise:
1
A cycle that is underway can only be modifi ed if it has only been running for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refi lled (see the section entitled “Loading the
Detergent”).
2
Press the start / pause button and the dishwasher will stop, press the Program button for more than 3
seconds, the machine will be in standby state, then you can change the program to the desired cycle
setting (see the section entitled “ Starting a wash cycle. . .” ).
3
The wash cycle status will appear on the display:
a) “H:MM” not fl ashing - program was paused or the dishwasher is in stand-by mode.
b) “H:MM” fl ashing - the dishwasher is running.
NOTE:
When you open the door during the wash cycle, the dishwasher will pause. “0:00” will stop fl ashing
on the display and a signal will be made every minute until the door is closed. The dishwasher will
start approx. 10 seconds after the door is closed.
Forgot to add a dish?
A forgotten dish can be added any time before the detergent cup opens.
1
Press the start / pause button.
2
Open the door slightly.
3
Add forgotten dishes.
4
Close the door.
5
The dishwasher will run after 10 seconds.