Philco PD 1070 BiX, User Manual

Page: 27 / 116

EN - 25
08/2012 Copyright © 2012, Fast ČR, a. s.
WARNING!
Short programs do not include the drying function. The above mentioned values were obtained on
the basis of laboratory tests according to relevant standards. These values may change depending
on conditions such as the type of dishes used, degree of dirtiness, type of dishwashing detergent,
water pressure, water hardness, etc.).
Turning on the appliance / starting a washing program
1. Pull out the lower and upper rack, load it with dishes and then slide back in.
We recommend that you fi rst load the lower rack and only then the upper rack (see “Load the dishwasher
racks”).
2. Fill the compartment with dishwashing detergent (see section “Dosage of the dishwashing detergent”).
3. Connect the power plug to the power socket. Power source is 220 - 240 V ~ 50 Hz, power socket specifi cation
12 A, 250 V ~. Check that the water inlet is fully open.
4. Press the ON / OFF button. The Start/Pause indicator light will turn on.
5. Repeatedly press the program button to select the desired program.
6. If necessary select an additional function.
7. Press the Start/Pause button to start the program. The indicator light of the selected program will turn off
when the program is started.
Monitoring the program
After the completion of a washing cycle the “end” indicator light will be lit and a sound will be made fi ve times.
NOTE:
Do not open the dishwasher until the ‘end of washing cycle’ indicator light turns on. During the drying
process the dishwasher will not make any sound for 40 – 50 minutes. This is a normal event.
Changing a program
A) Changing a program that is already running
1. Carefully open the door and allow the current program to stop and excess steam to be released.
2. Use the program button to select a new washing program.
3. Close the door and the new washing program will start.
B) Changing a program by resetting
1. Carefully open the door and allow the current program to stop and excess steam to be released.
2. Press and hold the program button for approximately 3 seconds. The “end” indicator light will start
fl ashing and “1” will appear on the display.
3. The dishwasher will drain the water after the door is closed.
4. Then a sound will be made fi ve times indicating the end of the program.
WARNING!
It is dangerous to open the dishwasher door during a wash because you could be scalded by hot
water.