®
9
®
10
Multiple system setup
Step 3: Manual setup
Short press (tap) the “
▲
”up and “
▼
”down
buttons to select the desired frequency.
*NOTE:
For PWR-6000, press the “
▲
” up and
“
▼
” down buttons to select the desired channel
first. The selected channel will flash, and please
press SET to confirm. Then follow the step above.
Step 4: Pair up the receiver and transmitters
①
One short press of the SET button again to initiate the IR synchronization.
②
Vertically aim the IR window of a transmitter to that of the receiver.
*NOTE:
The signal indicator “ ANT ” indicates the frequency is successfully synchronized. The audio
indicator “
(
(
(
ANT
)
)
)
” flashes to indicate the frequency is receiving audio signals.
VERTICALLY
VERTICALLY
The receiver is scanning
the best frequency.
Select and confirm the channel
first, and then scan the frequency.
“L ON ” for locking in,
and “L OF” for locking off
The best frequency
is found.
*NOTE
AutoScan setup
*NOTE
Step 3: AutoScan setup
①
Long press (2s) the SET button of the receiver
to initiate the auto-scan function, which searches
for the best frequency in the RF environment.
②
Wait until the new frequency appears on the screen.
*
NOTE:
For PWR-6000, press the “
▲
” up and “
▼
” down
buttons to select the desired channel first. The selected
channel will flash, and please press SET to confirm. Then
follow the steps above.
Long press the “
▲
” up button of the receiver for two seconds to lock your settings and to avoid a
ccidental touch.
*NOTE:
For PWR-6000, press the “
▲
” up and “
▼
”down buttons to select the desired
channel first. The selected channel will flash, and please press SET to confirm. Then follow the step above.
You are suggested to use no more than 20 transmitters simultaneously
（
band and RF environment
depend).
Turn on any other equipment that could cause interference during the performance so it will
be detected during the group and channel scans in the following steps.
Before you begin system set up, turn all receivers ON and all transmitters OFF.
①
Initiate the auto-scan function for a channel of a receiver.
②
Turn on the first transmitter and pair it up with the receiver.
③
Repeat the above two steps until set up all channels.
④
Leave transmitters on and continue with additional systems according to the above three steps.
Optional step: Initiate the lock function
▲
SET
▼
2s
▲
SET
▼
2s
▲
SET
▼
▲
SET
▼
MHz
G.
CH
G.
CH
▲
SET
▼
2s
▲
SET
▼
MHz
G.
CH
G.
CH
▲
SET
▼
▲
SET
▼
IR
PWR-6000
Select the channel first,
and then lock your settings.
*NOTE
▲
SET
▼
▲
SET
▼
IR
PWR-6000
▲
SET
▼
IR
MHz
G.
CH
▲
SET
▼
IR
MHz
G.
CH
ANT
(
(
(
(
(
(
