6441-473A
SERIES GRB DESIGN 2 [6] GRIPPERS
REPAIR PROCEDURES
PHD, Inc. makes no warranty as to the fitness of its products or as to the length of service life after being repaired or parts replaced by anyone
other than authorized employees of PHD, Inc. In no event shall PHD, Inc. be liable for loss of profits, indirect, consequential, or incidental
damages arising out of the use of PHD products.
For additional technical assistance, call or visit our web site:
P.O. Box 9070, Fort Wayne, IN 46899
www.phdinc.com
1-800-624-8511 • 260-747-6151
FIGURE 2
FIGURE 3
MAGNET OR OPEN GROOVE
OF PISTON IS ALWAYS
ORIENTED TOWARDS SHOCK
PAD DURING ASSEMBLY
RADIUS OF WASHER FACES
AWAY FROM PISTON
(SIZES 32, 40, & 50)
SHARP EDGE OF
RETAINER FACES
OUTWARD
ANGLE LIMITING
SPACER
ROD SEAL
*NOTE ORIENTATION
DRIVER PIN
DRIVER PIN SLOT
FRONT FACE
OF GRIPPER
TURNED DOWN
DIAMETER -CU
OPTION
SHOULDER OF
JAW PIVOT PIN
JAW COVER ASSEMBLY
FASTENERS
DRIVER PIN
FRONT FACE
OF GRIPPER
JAW PIVOT PIN
JAW COVER
JAW DRIVER
ROD
ROD SEAL
(SEE FIGURE 2)
JAW SLOT
BODY ASSEMBLY
JAW
OPTIONAL ANGLE
LIMITING SPACER
SHOCK PAD
PISTON
PISTON SEAL
WASHER
(SIZES 32, 40, & 50)
PISTON ASSEMBLY
FASTENER
BORE PLUG
BORE PLUG SEAL
BORE PLUG RETAINER
BORE PLUG
FIGURE 1
