9
8
Command
Description
EM
Setting EDID MODE. 1-STD 2-TV
?
Display all the available commands
UARTBAUD
?
Display each output's baud rate setting
1: 9600bps
2: 14400bps
3: 19200bps
4: 38400bps
5: 57600bps
6: 115200bps
UARTBAUD2
Set output B’s baud rate from 1~6
UARTBAUD3
Set output C’s baud rate from 1~6
UARTBAUD5
Set output E’s baud rate from 1~6
UARTBAUD6
Set output F’s baud rate from 1~6
UARTSW
?
Display output’s UART status.
UARTSW0
Switch to MCU. Restoring RS-232 control
to the Receiver output back to Matrix.
UARTSW2
Switch RS-232 control to output B and
allow Matrix to send commands to
Receiver’s connected RS-232 device.
UARTSW3
Switch RS-232 control to output C and
allow Matrix to send commands to
Receiver’s connected RS-232 device.
UARTSW5
Switch RS-232 control to output E and
allow Matrix to send commands to
Receiver’s connected RS-232 device.
UARTSW6
Switch RS-232 control to output F and
allow Matrix to send commands to
Receiver’s connected RS-232 device.
Quit
Exit (for telnet only)
9
Note:
1. All the command will be not executed unless followed with a
carriage return. All letters are case-insensitive.
2. Once switch RS-232 control to output Receiver all control can only
be done under RS-232 system.
3. Output Receiver's RS-232 equipment baud rate must be set correctly
in order to allow the Matrix to send through the commands.
