1
LHP100GK
2.4GHz Smart Camera
The LHP100GK is a 2.4GHz IR Surveillance Camera which can be installed indoors
or outdoors. The 2.4GHz wire free camera module will transmit audio/video signals
to the host LHK110EK 7” Touch Panel receiver for monitoring and recording
purposes. The host LHK110EK can pair with and control devices such as 2.4GHz IR
cameras, wire free O-net Security devices, and On/Off Plugs. Please see your
LHK110EK Instruction Manual for details.
INTRODUCTION
The LHP100GK features multiple IR LED’s that activate at night (or low light levels)
to ensure a sharper image. The built in microphone transmits sound to the host
LHK110EK. Status LED’s, green and red indicate day or night mode.
OPERATION
1. Status LEDs
1.1 Plug the supplied AC adaptor into an AC socket, and then plug the DC jack into
the IR camera cable. The green LED will illuminate when the power supply is
normal and the camera is in day mode.
1.2 The red LED will illuminate when the light level is low, indicating that the IR
LED’s are active and the camera is in night mode.
OPERATION (Continued)
2.
Pairing Button
2.1
The pairing button on the IR camera power input cable is used to pair the camera
with the host LHK110EK.
3.
ID Code Learning
3.1 Put the host LHK110EK into the “Pairing” screen for IR Camera (From
“Standby” mode, tap “Setting (Camera)”, select Camera number and IR
Camera, then tap “Pair”).
3.2 Press the Pairing Button on the IR Camera to pair the devices. When pairing is
complete, a “Pairing Successful” screen will appear on the LHK110EK and it
will automatically link to the camera. The user may now switch to the camera
view to confirm if the linking and pairing was successful.
3.3 If “Pairing Failed” appears, please repeat steps 3.1 and 3.2. Note the devices
only remain in pairing mode for 30 seconds. Please see your LHK110EK
Instruction Manual for more information.
4.
Video / Audio Functions
Under normal operating conditions, the LHP100GK Camera image can be
viewed from the host LHK110EK or via your smart device. If the LHK110EK
system is triggered by a security device paired on the system (PIR, Magnetic
Contact etc.) the LHP100GK will be activated and begin transmission of video
/ audio signals in H.264 format via 2.4GHz wire free signal to the LHK110EK.
INSTALLATION
1.
In order to ensure correct function do not install the camera near a heat source
or where direct sunlight will shine into the camera lens. Avoid high humidity areas
eg. bathrooms or kitchen areas where steam may ‘fog’ the camera lens. Do not
mount the camera on or near metalwork since this can block the camera signals.
2.
The camera may be used indoors or outdoors. The camera cable DC jack plug
/ socket is designed to be weather proof. Ensure the DC jack plug / socket is pushed
fully home to avoid moisture ingress.
