T E C H N O L O G Y
CI-10 VIII CI-20 VIII CI-40 VIII CI-60 VIII CI-70 VIII
Install instructions for CI rectangular flush mounts models:
8005 W. 110th St. | Suite 208 | Overland Park, KS 66210 | 855.663.5600 | www.phasetech.com | www.mseaudio.com
1.
Choose the appropriate mounting location
for each speaker.
Flange Installation:
Speaker Installation:
2.
Remove the speaker and flange/grille
assemblies from their boxes. Using the supplied
cutout template, carefully mark the area to be
cut out. Using a drywall knife or saw, cut the hole
in the drywall and prepare the speaker wires for
connection to the speaker terminals.
3.
Remove the grille from the mounting flange
by pressing it from behind. Attach
the provided white gasket material to the
outside, rear edge of the flange. Insert the
mounting flange into the hole with the end
marked “TOP” facing up. Loosen the flange
clamping screws one turn (counter clockwise)
to release the clamp. Use a level to insure that
the flange is square. Next tighten all 4 flange
clamp screws evenly to secure the flange to the
wall. It is best to tighten each screw with the
same amount of force (torque).
CAUTION:
Do
not over tighten.
7.
Tighten down the four QM clamps by pressing
them down flush with the baffle’s surface.
6.
Insert the baffle into the mounting flange,
aligning QM clamps with the four QM posts. Also
make sure that the tweeter is placed at
the end of the flange marked “TOP”.
4.
Use the provided tool to fully open the four
Quick Mount™ (QM) clamps. If the tool is not
available a small screw driver can be used.
NOTE –
When deciding upon a location
consider the following:
• Be certain your speaker wires can be run to or are
accessible from these locations.
• Make certain the wall or ceiling material is sturdy
enough to support the weight and vibration of the
speakers.
• It is recommended that our pre-construction rough
in brackets (part number RB-18*) be used whenever
possible in new construction.
• Be certain the area behind the speaker is free of
obstacles such as wall studs, electrical wiring, pipes,
etc.
• Each speaker should be positioned properly relative
to the listening area for good coverage.
• Audio performance and room-to-room isolation will
be improved if there is some fiberglass insulation
placed loosely behind the speaker.
8.
Using some familiar source material, listen to the
tweeter’s balance with the level control in each of
its three positions to find your favorite.
9.
Carefully install grille by pressing it into the gap
between the flange and the baffle and enjoy your
new Phase Technology CI speakers.
5.
Connect the speaker wires to the spring loaded
input terminals on the rear of the speaker, making
sure no loose strands are exposed.
red/positive black/negative
+
–
flange screw
