1. Unpack speaker. Leave
paint mask in place until
after speaker is installed or
painting is complete.
3. Use RotoZip or other tool
to cut hole. Hole diameter:
5.6 in. (142 mm).
5. If required, attach seismic
restraint system to hole in
clamping arm, then to
reinforced structure (safety
cable not included).
7. Remove paint mask
unless painting is required.
In that case, follow steps
8-11 when painting is
complete.
1.
2.
9. Attach grille safety clip by
placing the large end of the
clip over snap-fit post (1),
then sliding clip until small
end snaps into place around
post (2).
10. Align tabs on snap-fit
grille with slots in baffle,
gently press grille into place.
11. Done!
T E C H N O L O G Y
Installation Instructions: Installing the
CI-1.5 in a Sheetrock Ceiling
R
8. Adjust tap switch to
proper setting. Switch is
preset to 8-ohm mode.
2. Use hole template to
mark cutout on sheetrock.
6. Insert speaker into
mounting hole with paint
mask in place. Tighten both
screws on the baffle face to
actuate the mounting wings.
Firmly secure both screws,
DO NOT OVERTIGHTEN.
4. Connect Euroblock to
speaker wires, and connect
to speakers.
