7
[MOUNTING THE CINEMICRO
®
ONE ON A WALL]
The four satellites and center channel include keyhole-style inserts for on-wall mounting. Use an 8 mm screw in a drywall anchor capable of
holding 2-3 times the weight of the speaker in the location you wish to mount the speaker. Leave the screw head about 1/4” out of the anchor,
then slide the keyhole insert over the screw. Additionally, the four satellite and one center channel speakers feature M5 (5 mm) threaded
inserts mounted on the rear or bottom of the speakers for use with standard wall mounting brackets (available from third party vendors).
[TABLE TOP OR SHELF PLACEMENT]
Included with your CineMicro
®
speakers are self adhesive bumpers that can be used on the bottoms of the speakers to protect the finish when
placing it on a shelf or table top. Simply peel off four of the bumpers from the backing paper and apply the four bumpers to the bottoms of
each of the satellite speakers. To keep the center channel speaker from rocking and to level the speaker, two angled plastic feet are included
that can be attached to the bottom of the speaker cabinet. Use to two supplied screws to attach the feet to the left and right threaded inserts
in the bottom of the cabinet. Two extra bumpers are also included to apply to the bottom of the speaker to protect the finish of the cabinet.
[SUBWOOFER CONNECTIONS]
OPTION 1: LOW LEVEL SETUP
This is the recommended method for those amplifiers and receivers that are equipped with a “Subwoofer
Out” or “Pre-Amp Out” connection. Virtually all audio/video receivers have this connection clearly marked on the rear panel. Run a dedicated
interconnect cable with RCA connectors from the subwoofer output jack to the line input on the subwoofer. In this setup, you will be using
the internal crossover on your processor.
OPTION 2: HIGH LEVEL INPUT SETUP
If your amplifier or receiver does not have a dedicated subwoofer output, it will be necessary to
connect your new subwoofer directly to the speaker output terminals on the back of the unit. In this scenario, you will be running high quality
speaker wires from the left and right front outputs of your amplifier to the high level inputs on the subwoofer. You will then need a second set
of wires to carry the signal from the subwoofer back to the main speakers.
