T E C H N O L O G Y
Installation Instructions: Installing the CI-15
Using the Pre-Construction Bracket
R
1.
2.
4.
r. Leave
paint mask in place until
after speaker is installed or
painting is complete.
6. If required, attach
seismic restraint system to
the hole in the metal
clamping arm, then to
reinforced structure (safety
cable not included).
12. Done!
1. Nail or screw bracket to
studs.
2. Finish installing wall.
3. Use RotoZip or other tool
to cut hole.
8. Remove paint mask
unless painting is required.
In that case, follow steps
9-12 when painting is
complete.
7. Insert speaker in hole.
Tighten the two clamping
screws.
DO NOT
OVERTIGHTEN.
10. Attach grille safety clip
by placing the large end of
the clip over snap-fit post
(1), then sliding clip until
small end snaps into place
around post (2).
11. Align tabs on snap-fit
grille with slots in baffle,
gently press grille into
place.
9. Adjust tap switch to
proper setting. Switch is
preset to the 8-ohm mode.
Unpack speake
5. Connect Euroblock to
speaker wires, and connect
to speakers.
