Phase Technology 70Xi-APA/ APC/ ASL Analyzer System – Quick Installation Guide
Page 1 of 3
Customer Service & Support: 604-241-9568
1.
Remove the following items from the 3 boxes:
70Xi analyzer box:
1 70Xi analyzer
1 accessory box:
-
1 AC power
cable
-
1 dryer bottle
Autosampler
box:
1 Autosampler
1 accessory box:
-
1 AC power cable
-
1 RS232 cable
-
2 vial heater/sample
rack
(*APA & APC: 2 vial heaters)
(*ASL: 1 vial heater & 1 rack)
Accessory box:
1 waste tank with grounding cable
1 box with solvent tank with grounding cable
1 box with pour sprout (level sensor attached)
1 bag of tubings and cables
2.
Set up the analyzer system:
The system should be set up:
-
on a flat, vibration-free bench with room underneath
-
in a well-ventilated location
Put the autosampler on the right side of the analyzer, with
the AC power cable connector facing the back.
Put the waste tank and solvent tank under the bench.
3.
Remove 2 plastic caps and 7 swage caps on the back of the
analyzer, and 3 plastic caps at the solvent tank. Keep them
with the shipping boxes and related packing materials.
4.
Connect the dryer bottle to the back of the analyzer:
a)
Attach the dryer bottle to the
back of the analyzer by fitting
the two mounting bracket holes
over the two mounting screws.
b)
Separate the quick-connect
fittings on the dryer bottle. Press
the latch on the female fitting
and pull them apart.
c)
Attach the quick-connect fittings
to the “PURGE IN” and “PURGE
OUT” fittings on the back of the
analyzer. A “click” sound
confirms that the fittings have
snapped into place.
5.
Load the two vial heater/sample rack to the autosampler.
Make sure the 4 feet of each vial heater/sample rack sit
inside the square cutouts of the autosampler bottom tray.
8 square cutouts on the
bottom tray
Vial heater/sample
rack on the bottom
tray (*put the vial
heater with wash pot
at front)
6.
Use wrench to connect the tubing to back of the analyzer:
Port at back of analyzer:
Tubing:
“From Base of Wash Pot”
Labeled
“From Base of Wash Pot”
“To Waste Tank”
Labeled
“To Waste Tank”
“Air to Solvent Tank”
Labeled
“Air To Solvent Tank”
“Sample From
Auto-Sampler”
Labeled
“Sample From Autosampler”
(the other end of the tubing
already attached to the
larger needle of the
autosampler probe)
“Solvent From
Solvent Tank”
Labeled “Solvent From
Solvent Tank”
“From Top of Wash Pot”
Labeled
“From Top of Wash Pot”
(the other end of the tubing
already attached to top of
wash pot of the vial heater)
“Air to Auto-Sampler”
Labeled
“Air To Autosampler”
(the other end of the tubing
already attached to the
smaller needle of the
autosampler probe)
