2/11
©
PHANTOS
®
Distributed in Australia by PHANTOS www.phantos.com.au
voids all warranties.
▪
Always turn off, unplug power and allow fixture to cool before
servicing.
▪
Ensure that fixture is properly grounded. Do not attempt to remove
or break off the ground prong from the electrical cord. This prong is
used to reduce the risk of electrical shock and fire in case of an
internal short.
▪
Always make sure that you are connecting to the proper voltage
and that the line voltage you are connecting to is not higher than
that stated on decal or rear panel of the fixture.
▪
To prevent risk of fire or shock, do not expose fixture to rain or
moisture.
▪
Make sure power cord is never crimped or damaged. Do not
attempt to operate this unit if the power cord has been frayed or
broken.
▪
Do not remove the cover under any conditions, unless consent
given by distributor. There are no user serviceable parts inside.
▪
Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 15cm between this device and a wall.
▪
DO NOT connect this product to a dimmer or rheostat.
▪
ONLY connect this product to a grounded and protected circuit.
▪
ONLY use the hanging/mounting bracket to carry this product.
▪
USE a safety cable when mounting this product overhead.
▪
DO NOT look at the light source when the product is on.
3/11
©
PHANTOS
®
Distributed in Australia by PHANTOS www.phantos.com.au
2. SET UP
2.1 Mounting
With adjustable mounting double brackets, this unit may be wall
mounted, free standing, or clamp mounted.
IMPORTANT!!! Safety cables must always be used. The safety
cable must be capable of holding 10 times the weight of the
fixture.
2.2 Fixture Linking
To run your light shows of one or more fixtures using a DMX-512 controller
or to run synchronized shows on two or more fixtures in master/slave
operating mode, you need DMX cables to link the units from DMX IN to
DMX OUT.
Only use standard 110-120 Ohm shielded cable. These are 2
core-screened cables, with each core having at least a 0.5mm
diameter. Do not use the ground lug on the XLR connector. Do not
connect the cable
’
s shield conductor to the ground lug or allow the
shield conductor to come in contact with the XLR’s outer casing.
Grounding the shield could cause a short circuit and erratic
behavior.
