Copyright © 2015 CYNWARK Corporation
www.PGFfan.com 888-938-6672
Boat Cup Holder Compatibility
Please Note:
It’s very important
NOT to have
the PGF-V installed in the cup holder
when under power at higher speeds and/or in rough water.
#
1
#
2
Polymer Boat
Ring
We have done our very best to engineer a system of adapters that will fit into most
O.E.M. boat cup holders. However, there are so many different versions on the
market today it is impossible to insure they fit into every single one. Two cup adapters
and one polymer ring are supplied with the PGF-V that fit into most boat cup holders.
These adapters are shown below. Each adapter is numbered on the bottom for easy
identification.
Cup holders designed with LEDs, tangs, or smaller diameters will use adapter number
2 without the polymer boat ring as shown below.
Most cup holders found in boats will utilize the number
1
cup adapter with the boat
polymer ring added. This combination of adapter/polymer ring and examples of the
cup holders it fits are shown below.
Cup Adapter
(1)
Polymer Boat Ring
Cup Adapter
(2)
Tangs
Is your PGF-V a little loose?
Every effort has been made to supply cup adapters that fit into the O.E.M. cup holders.
However, due to manufacturing tolerances the sizes can vary slightly. If needed, you can use
one of the following methods to create a more secure fit:
1. Wrap duct tape around the cup adapter
to increase the width.
2. Add a piece of velcro to the bottom of
the cup adapter and the cup holder.
Page 7
Page 8