PG Drives Technology SK78814/1, Technical Manual, Page: 23 / 24

PG D
RIVES
T
ECHNOLOGY
R-
NET
IOM - P
ROGRAMMING
1 Introduction
This chapter gives an overview of the specific IOM programmable parameters within the R-Net control system. The IOM
parameters can only be programmed using a PG Drives Technology R-Net PC Programmer.
Programming should only be conducted by healthcare professionals with in-depth knowledge of
PGDT Control Systems. Incorrect programming could result in an unsafe set-up of a wheelchair for
a user. PGDT accept no responsibility for losses of any kind if the programming of the control
system is altered from the factory pre-set values.
To connect the R-net PC Programmer to the Control System use the USB connection cable and R-net Dongle as shown below.
The Dongle can be connected to any point of the Control System.
The control unit must be connected and ON before program transfer can be achieved.
Check the Status Bar to see if the connection is correct. Refer to section 3.4.
Ensure the PC Programmer cable has been disconnected from the Control System before you start
driving.
2 Configuration
In the Configuration Menu you can define:
•
The Mode Name
• The Output Data that is sent from the Input Device to the Output Device.
• The Output Device that is active in each Mode.
When installing Input and Output Devices through an IOM it is only necessary to adjust these
parameters if Multiple IOM’s are fitted, or if the wheelchair has specific requirements. In these
instances refer to the R-net Technical Manual SK77981 for Programming Details.
SK78814/1 23