Turn water on/off switch to the
ON
position (left). Push the manual water button on control panel while at the
same time adjusting water volume to desired level. If not sure starting level
REMEMBER STARTING WETTER IS MUCH
BETTER THAN TOO DRY
. When desired level is reached release button, let water drain out of the
lower
water
connector. When water stops coming out replace cap.
Water volume adjuster knob
Run machine a few seconds then stop. Remove cap from lower water connector
AGAIN
, Push black water
button until water starts coming out then stop. Let water drain out. When water stops replace lower water cap.
Your machine is now primed.
Check mortar bin to make sure it is still dry. Add 1 bag of DRY mix. Make sure you empty the bag in nice and
slowly. Put a bucket in front of ROTOR STATOR nozzle to catch the mixed mortar.
Rotor Stator nozzle
Adjust speed switch to desired speed. Dry mix
MUST
be above “5” speed or water will shut off. Normally a good
starting speed is “8 - 9”. If using a
pre-mixed
wet material then under “5” speed is ok. Turn on pump motor switch
to the right. Check mortar mixture in bucket. Adjust water volume
SLOWLY
to get desired consistency. When
consistency is correct turn off pump motor. Mixture is ready. Remember it’s a good idea to start a little too wet
then adjust water volume down after you start spraying.
If you adjust speed later in the day you will need to
adjust water volume as well or mixture will change consistency.
Pump motor switch / Speed switch
