PFT JETSET pro in case Safety - Overview - Operation - Spare parts lists
Commissioning
26
2017-10-10
19 Commissioning
19.1 Prepare mortar hoses
1
Fig. 7: Prepare mortar hoses
1. Fill water into the mortar hose.
2. Remove all the water from the mortar hose.
3. Pre-lubricate the mortar hose with about one litre of wallpaper
paste.
4. Connect mortar hose (1) at the mortar pressure gauge.
5. Switch on the connected machine and allow it to run for a long
time until the mortar-filled mortar emerges.
NOTE!
Ensure clean and correct connection and tightness of
the couplings! Dirty couplings and rubber seals are not
watertight, and water might leak under pressure
inevitably leading to blockages.
DANGER!
Torn off hoses can beat about and injure
bystanders!
Never loosen the hose couplings as long as there is
pressure on the mortar hoses (check mortar
pressure gauge)! The mix could burst out under
pressure and result in serious injuries, especially
injuries to the eyes.
20 Connect JETSET pro spraying gun
1
4
3
2
Fig. 8: Connect spraying gun
1. Close the hand lever (1).
2. Connect the mortar hose (2) to the spray gun.
3. Connect the air hose (3).
4. Connect remote control (4).
