139
127
M3 or Ø3.5
122
.5
113
Fig. 11:
Required control panel cut-out
Installing the device in a switchboard
Required tool
● Screwdriver
Required material
● 4 screws (M3 or equivalent)
1. Support the device from below to relieve the front panel.
2. Push the device into the control panel cut-out.
3. Fasten the device using 4 screws.
2.3 Using the device as a desktop device
NOTICE
Damage caused by overheating
The ambient temperature must not exceed the permissible operating temperature of the device.
► Make sure there is unobstructed circulation of air when installing the device.
► Periodically check and clean the installed air filter, if necessary.
Fig. 12:
Fastening the rubber feet and rubber strip
Installing
Summary of Contents for PT G28 500
Page 99: ......
